Simulation of fuel injection through a nozzle having different position of the spray holes
DOI:
https://doi.org/10.21533/pen.v7.i1.1515Abstract
In the article, a method of hydraulic calculation of working process of a diesel fuel feed system having a nozzle with different positions of its spray holes was investigated. A research of diesel engine injector nozzle design which had two groups of holes was carried out. Entering edges of the first group with the coefficient of flow μhl were located in the sack volume and entering edges of the second group (coefficient of flow μhu) – on the locking taper surface of the nozzle body. The coefficients of flow μhl and μhu differ considerably and depend on the valve needle position. This enables to distribute rationally the injection quantity by injection holes taking into account operating conditions of the diesel engine and hence – by the combustion chamber zones.
Downloads
Published
Issue
Section
License
This work is licensed under a Creative Commons Attribution 4.0 International License.
Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
